We are using Metric with drawing settings of 1:1000 (1mm = 1m)Īny suggestions on how to track down and eliminate these rogue scale factors?ġ:1_1 was referenced on the Model tab, 1:1_2 was referenced in Page Setups CMW_A1_DWG-PDF and REDACTION_Plot_Settings_A1_AcroPlot. This has gotten to the point where sheet views are not displaying or scaling correctly because the 'model space' might be set at 1:1, and the vport has a scale of 1:1_2 (so they don't 'match'). They don't appear to be pulling from the xrefs either. We figured it had something to do with scale factors being set inside of the label settings, or other C3D specific functions. I'm posting this in the C3D area, as I have not run into this issue to this extent outside of C3D - we had a previous project in version 2016 that this was also happening in. I read somewhere, that since the scale bar names cannot be duplicated if there is a difference between them, it adds the underbar_sequence number, but these are all the same percentage and factor values. These aren't the same as the dreaded "_XREF" ones, but they are duplicates of other scales. I'm getting a bunch of "underbar" scales in my Scale List. This has probably been answered before, but search isn't bringing up anything, so here goes:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |